How to remove a garbage disposal drain plug

#HOW TO REMOVE A GARBAGE DISPOSAL DRAIN PLUG FULL#

The safest way is to place the disposal on the floor and tap out the plug with a screwdriver and hammer. You risk damaging the sink or the disposal doing this however, so you might want to place someone or something behind it to prevent it from moving do you your hammer strikes. If you have forgotten to remove it and the new disposal is already installed, you can remove the drain hose from the nipple and use a screwdriver and a hammer to tap it loose. If you are connecting a dishwasher to the nipple, you need to remove the plug. If you do not have a dishwasher (and therefore wonвЂ™t be connecting one to the nipple), you donвЂ™t need to do anything to the plug. If you donвЂ™t remove this plug the water will back up into the air gap and onto your counter. In this nipple is a plug that must be removed so that the drain water will flow freely into the disposal and out of the trap. If you have a dishwasher, the drain line connects to an air gap and then drains into a nipple at the side of the disposal. The purpose of the plug is to create a watertight seal in the event you donвЂ™t have a dishwasher. When your garbage disposal or plumbing needs service or repair, contact Len The Plumber.A very common oversight when installing a garbage disposal is forgetting to remove the knock-out plug from the side of the unit. Removing glass from a garbage disposal isnвЂ™t difficult - but it is dangerous. Run the tap to wash away any extremely small piece of glass that might linger behind. Once all of the glass has been removed, turn the power back on for the garbage disposal. Suck up any remaining glass with your vacuum. Do this by using a hex key underneath the disposal, or by using a broom handle (or stick) via the drain opening to turn the blades. To remove the last bits and pieces of remaining glass, youвЂ™ll need to turn the blades of the disposal. Some pieces will need to sucked out one by one if the opening of the nozzle isnвЂ™t wide enough.

Slide the metal clamp on the dishwasher discharge hose to the attachment point on the replacement garbage disposal unit and tighten the clamp using a screwdriver. This will attach to the place where you knocked out the plug. If you donвЂ™t have this long, yet skinny attachment, tape thin PEX tubing to the nozzle of the vacuum. Connect the dishwasher drain hose that was attached to your old disposal unit to your new disposal unit. Allow the disposal to run while all the water runs out. Remove the drain plug and immediately turn on the disposal.

#HOW TO REMOVE A GARBAGE DISPOSAL DRAIN PLUG FULL#

Till the sink about three-quarters full of cold water, adding a bit of dish soap. Using the long-head attachment, begin sucking out glass from the drain opening. With the disposal off, plug the sink drain with the stopper. Next up, bring your Shop Vac into the house from the garage. Most of the bigger pieces will live toward the top of the drainвЂ™s opening. Instead, grab a pair of needle nose pliers and begun pulling out as many pieces as you can find. Step 2: Go FishingДЇirst things first, do not stick your hand into the drain in hope to pull out the glass. You can turn off the power on the disposal itself, but just to be safe - switch off the breaker at the panel too. Great! Now we have to fish these pieces out very, very carefullyвЂ¦Д«efore you do anything, the power being supplied to the garbage disposal must be turned off. Unfortunately, glass and other broken shards can make their way into your sinkвЂ™s garbage disposal. Glasses and dishware can occasionally break when theyвЂ™re handled in the sink.

How to remove a garbage disposal drain plug